| The 
                    generation of maritime cloud condensation nuclei (CCN) through 
                    the ejection of jet and film droplets from bursting whitecap-produced 
                    bubbles on the ocean surface has been well documented. The 
                    processes involved in the transformation (evaporation and 
                    crystallization) of these liquid droplets into their solid 
                    form under varying conditions, however, has not previously 
                    attracted much attention from atmospheric researchers. A 
                    set of laboratory investigations and field observations of 
                    the characteristics, both physical and chemical, of seawater 
                    droplets during phase change in a controlled environment have 
                    revealed the following startling and very significant phenomena: 
                     
                     
                      | (1) 
                          The ejection of sulfate aerosols (CaSO/4,MgSO/4) with 
                          size range of 0.1mm to 10 mm. The concentration and 
                          chemical composition of the ejected aerosols, identified 
                          by the techniques of scanning electron microscopy and 
                          energy dispersive x-ray spectroscopy, were dependent 
                          on the rate of droplet evaporation. Sea-salt aerosols 
                          could be classified into three categories: (A) NaCI 
                          crystals, (B) Crystals of sulfates (CaSO/4,MgSO/4) and 
                          (C) Chloride droplets (MgCI/2, KCI). 
                           |   
                      | (2) 
                          The formation of hollow spherical sea-salt particles 
                          (>5 mm). A secondary ejection of aerosols was detected 
                          during melting by the busting of air bubbles, which 
                          were formed when the hollow particle was moved into 
                          a high-moisture environment or dissolved into a water 
                          droplet. |   
                      | (3) 
                        A thin 
                        film of chlorides (MgCl/2, KCI) observed on the surface 
                        of sea salt particles present a highly hygroscopic surface 
                        to initiate the condensation of water vapor in an environment 
                        with RH As low as 40%. Sodium Chloride (NaCI-75%RH) 
                        plays only a minor role for the formation of cloud droplets 
                        in the marine atmosphere. |  Characterization 
                    of the ejected sulfate aerosols in comparison with field observation, 
                    chemical processes inside the evaporating seawater droplets 
                    and the mechanisms for the generation of secondary aerosols 
                    in the marine atmosphere are presented with illustrations. 
                     .jpg)
 |